Rear camera 1 Main

Watch the tutorial on YouTube

Replacement Instructions

5 min
Very Easy

Requirements:

A soft surface
– You can use a towel, for example
Spudger
Micro screwdriver

Place the SHIFTphone upside down on a soft surface.

This prevents scratches on the SHIFTphone.

Then, remove the battery cover using the opener at the side of the battery cover.

Place the SHIFTphone with the camera facing up on a soft surface.

Take the opener and place one end in the middle beneath the battery.

Then make a 45-degree motion with the opener and lift the battery up.

Carefully unscrew all 8 screws.

Use a suitable screwdriver to prevent damage.

Set the screws aside so you don’t lose them.

Hold the SHIFTphone firmly on both sides.

Unscrew the fasteners at the bottom.

Apply just enough force to loosen them.

Use a spudger to carefully pry the screen loose.

Run along the edges to pop the clips loose.

Do not detach the screen without first loosening everything.

Locate the position of the main camera in the device.

Gently place the spudger under the connector.

Carefully pry the main camera loose with the spudger and remove it from the device.

Take the new main camera and position it in the correct place in the device.

Carefully connect the connector to the motherboard.

Gently press the main camera down and check that it is securely in place.

Carefully lay the screen display back on the case.

Press the screen firmly along the edges.

Check that the screen is securely in place all around.

Reinsert the battery into the SHIFTphone.

Place it correctly in the SHIFTphone.

With the SHIFT logo facing up and the + and – at the top left.

Place the SHIFTphone upside down again on a soft surface.

Take the battery cover and lay it back on the SHIFTphone correctly.

Press on 8 points to ensure the battery cover is secure.