Rear camera 2 Wide

Watch the tutorial on YouTube

Replacement Instructions

5 min
Very Easy

Requirements:

A soft surface
– You can use a towel, for example
Spudger
Micro-screwdriver

Place the SHIFTphone upside down on a soft surface.

This prevents scratches on the SHIFTphone.

Then, remove the battery cover using the opener on the side of the battery cover.

Place the SHIFTphone with the camera facing up on a soft surface.

Take the opener and place one end in the middle underneath the battery.

Then make a 45-degree motion with the opener and lift the battery upwards.

Carefully unscrew all 8 screws.

Use a suitable screwdriver to avoid damage.

Place the screws aside so that you don’t lose them.

Hold the SHIFTphone firmly on both sides.

Unscrew the fasteners at the bottom.

Apply just enough force to unscrew them.

Use a spudger to carefully release the screen.

Run along the edges to disengage the clips.

Do not detach the screen without first loosening everything else.

Locate the position of the wide camera in the device.

Gently place the spudger under the connector.

Carefully pry the wide camera loose with the spudger and remove it from the device.

Take the new wide camera and position it in the correct place in the device.

Carefully connect the connector to the motherboard.

Gently press the wide camera in place and ensure it is securely fitted.

Carefully place the screen display back on the case.

Press the screen firmly along the edges.

Check that the screen is securely fitted all around.

Reinsert the battery of the SHIFTphone.

Place it in the correct orientation in the SHIFTphone.

With the SHIFT logo facing up and the + and – at the top left.

Lay the SHIFTphone upside down again on a soft surface.

Take the battery cover and place it back correctly on the SHIFTphone.

Press down firmly at 8 points to ensure the battery cover is secure.