Bottom daughterboard

Replacement Instructions

<div clasWatch the tutorial on YouTube

s=”time”>5 min
Very easy

Required tools:

A soft surface
– For example, you can use a towel
Spudger
Micro screwdriver

Place the SHIFTphone upside down on a soft surface.

This prevents scratches on the SHIFTphone.

Then remove the battery cover using the opening tool at the side of the battery cover.

Place the SHIFTphone with the camera facing up on a soft surface.

Take the opening tool and place one end in the middle under the battery.

Then make a 45-degree motion with the opening tool and lift the battery upward.

Carefully loosen all 8 screws.

Use a suitable screwdriver to prevent damage.

Set the screws aside so you don’t lose them.

Hold the SHIFTphone firmly on both sides.

Unscrew the fasteners on the bottom side.

Apply just enough force to loosen them.

Use a spudger to carefully loosen the screen.

Work along the edges to release the clips.

Do not detach the screen before everything has been loosened.

Remove the 2 screws.

Take off the metal bar after loosening the screws.

Disconnect the main FPC cable from the housing.

Unscrew the fasteners on the board.

Carefully lift the board up.

Turn the board over and remove the microphone, USB connector, and the two side cables.

Attach the two side cables.

Secure the USB connector and the microphone, and connect the main FPC cable to the bottom of the daughterboard.

Then screw the daughterboard back into place.

Place the main FPC cable back.

Lay the metal bar back in the correct position.

Tighten the two screws again.

Carefully place the screen display back on the housing.

Press the screen firmly along the edges.

Check if the screen is securely attached everywhere.

Place the SHIFTphone battery back.

Insert it into the SHIFTphone in the correct orientation.

With the SHIFT logo facing up and the + and – symbols in the top left corner.

Place the SHIFTphone upside down again on a soft surface.

Take the battery cover and place it back on the SHIFTphone in the correct way.

Press firmly on 8 points to ensure the battery cover is securely attached.