Metal cable holder

Watch the tutorial on YouTube

Replacement Instructions

5 min
Very easy

Required:

A soft surface
– For example, you can use a towel
Spudger
Micro screwdriver

Place the SHIFTphone upside down on a soft surface.

This prevents scratches on the SHIFTphone.

Then remove the battery cover using the opener on the side of the battery cover.

Place the SHIFTphone with the camera facing up on a soft surface.

Take the opener and place one end in the middle under the battery.

Then make a 45-degree motion with the opener and lift the battery up.

Carefully loosen all 8 screws.

Use a suitable screwdriver to avoid damage.

Set the screws aside so you don’t lose them.

Hold the SHIFTphone firmly on both sides.

Unscrew the fasteners on the bottom side.

Apply just enough force to loosen them.

Use a spudger to carefully loosen the screen.

Work along the edges to release the clips.

Do not remove the screen before everything has been loosened first.

Remove the 2 screws.

Take off the metal cable holder after loosening the screws.

Carefully remove the metal cable holder.

Take the new FPC cable holder and hold it with two fingers on both sides.

Carefully place it in the correct position.

Secure the FPC cable holder with the two screws.

Carefully place the screen display back onto the housing.

Press the screen firmly along the edges.

Check whether the screen is securely attached everywhere.

Place the SHIFTphone battery back in.

Insert it correctly into the SHIFTphone.

With the SHIFT logo facing up and the + and – in the top left.

Place the SHIFTphone upside down again on a soft surface.

Take the battery cover and place it back on the SHIFTphone in the correct orientation.

Press the battery cover firmly into place at 8 points.